1 - Introduction
tDynamo| Three-way Secure Card Reader Authenticator | Installation and Operation Manual
Page 13 of 39 (D998200257-20)
1.10 About Solution Planning
A smooth deployment of a tDynamo solution requires some up-front planning and decision-making:
Determine what type of host tDynamo will connect to. This can be a computer with a USB port or a
host with Bluetooth 4.0 hardware that supports Bluetooth LE. When planning, include any additional
support or devices required by the host, such as physical locations, mounting, and power connections.
Determine what software will be installed on the host and how it will be configured. Software can
include operating system, transaction processing software, security software, and so on. Include any
additional support required by the software, such as network connections.
Select which connection type the solution will use. tDynamo can connect physically via its USB-C
connector or to the optional docking stand, or via Bluetooth LE. It connects logically as a vendor-
defined HID device or GATT device, respectively. Be sure to specify the desired connection settings
when ordering the device. If necessary, they can be reconfigured afterward.
Determine how tDynamo should be configured, and specify that when you order devices. For
example, although tDynamo comes with a factory default Bluetooth LE passkey, it is a good idea to
choose and set non-default passkeys early in the planning process, or request non-default passkeys
when ordering devices.
Determine what the solution will use as a primary power source. tDynamo can be powered by a
USB host through the USB-C connector or the optional docking stand, or can be powered by its
internal rechargeable battery.
Determine the battery recharge schedule(s). For example, in high-traffic mission-critical solutions,
it may be wise to keep spare devices configured and charged for fast swap-out.
Determine how tDynamo will be physically presented to the cardholder. This includes whether the
device will be handheld, permanently mounted to a countertop in the optional docking stand, or
handheld and placed in the docking stand for easy charging. When planning placement, be sure to
consider the connection type and power source. For example, if the primary data connection is USB,
the mounting location should be within reasonable USB cabling distance from the host.
Determine how tDynamo will be branded. In large quantities, MagTek can accommodate custom
branding colors and trade dress. Contact a representative for details.
To Next Page
Loading...
