Mahindra 3016 - SPECIFICATIONS; ENGINE SPECIFICATIONS

SPECIFICATIONS
15
DIESEL ENGINE
GENERAL
TYPE Three Cylinders, Four Cycle, Valve in Cylinder Head, Cross Flow Porting
FIRING ORDER
3016 ............................................................1-3-2
3616 ............................................................1-2-3
BORE
3016 ............................................................78mm (3.071 inch)
3616 ............................................................84mm (3.307 inch)
STROKE
3016 ............................................................92mm (3.622 inch)
3616 ............................................................100mm (3.937 inch)
PISTON DISPLACEMENT
3016 ............................................................1318cm
3
(80.43 inch3)
3616 ............................................................1662cm
3
(101.4 inch3)
COMPRESSION RATIO
3016 ............................................................22.0 to 1
3616 ............................................................22.5 to 1
GOVERNOR ENGINE SPEED WITHOUT LOAD
3016 ............................................................2670 to 2690 RPM
3616 ............................................................2810 to 2835 RPM
RATED ENGINE SPEED
3016 ............................................................2600 RPM
3616 ............................................................2600 RPM
ENGINE IDLE SPEED
3016 ............................................................970 to 1000 RPM
3616 ............................................................995 to 1020 RPM
MAXIMUM HORSE POWER (Manufacturing Rating)
3016 ............................................................26 HP at 2600 RPM
3616 ............................................................34.5 HP at 2600 RPM
VALVE CLEARANCE (Intake and Exhaust Cold Engine)
3016 ............................................................0.25 mm (0.010 inch)
3616 ............................................................0.20 mm (0.008 inch)
IMPORTANT : Valve clearance adjustment must be made when the engine is not
running and is cold.