Mahindra BFMXTV60 - Control Box Installation Guide

10
ChooseoptionAorBtoinstallthecontrolboxsupport
(item1).
NOTE:Inordertopreventdamageduetowater
accumulation,makesuretoplacethecontrolbox
horizontally.
OptionA
Usetwohexbolts1/4"x11/2"(item2),twospacers
(item3)andtwoflangenuts1/4"(item4)toattachthe
controlboxsupporttothesupportbrackets(item5).
NOTE:Choosetherightholecombinationonthe
controlboxsupportinordertodirectthefrontofthe
controlboxtowardsthedrivingcontrolsofthevehicle.
(seeoperationsectiontoseehowcontrolboxis
oriented),Furthermore,makesuretohavefree
accessatalltimestotheequipment'scontrolsin
ordertosafelycontroltheequipment.
OptionB
Drilltwoholesof19/16’’apartonthevehicle.Secure
thecontrolboxsupportwithtwobolts1/4"x1/2"(item
6)andtwoflangenuts1/4".
STEP7
CONTROLBOXINSTALLATION
1) Remove the control box (item 1) from the guard
(item2)byremovingtheknob(item3).
TIP: The knob can stay on the guard. Once the
control box has been removed, make sure to
retightentheknobtoavoidlosingitbecauseofthe
vibrationswhentheaccessoryisinoperation.
2)Installtheseal(item1)onthesupport(item2)with
the hex bolt 5/16’’ n.c. x 3/4’’ (item 3), a flat
washer3/8’’hole(item4) andanylon insert lock
nut 5/16’’ n.c. (item 5). Do not tighten the seal.
Use the groove (item A) on the control box to
makesurethesealisnottootightandthatitslips
ineasily.
ASSEMBLY