EasyManua.ls Logo

Mahindra BFMXTV60 - Pre-Operation Checks and Procedures

Mahindra BFMXTV60
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
OPERATION
BEFOREFIELDOPERATION:
INSPECTTHEVEHICLE
The vehicle’s safety equipment is installed and in
goodworkingcondition.
Vehicleisin good workingconditionand must
respectthe m aintenancespecif icationsas per
theownersm anualofthevehicle.
ENGINEPREPARATION
See enginemanufacturer’s recommendationsfor the
typeandamountofoilandfuelused.
Make sure the tow vehicle’s parking brake is set,
mower is level, and blades are disengaged. Engine
must be level to accurately check and fill oil. Do not
overfill.
 Checksparkplugwire(s),oilandfuel.
 Check all electrical connections for debris
buildup.
Operate the engine according to the instructions in
theenginemanual.
ADJUSTCUTTER
Beforeoperating,refertosection« Adjustment »and
proceed with the required adjustments according to
thedesireduse.
ADJUSTTIREPRESSURE
Verifyandadjusttirepressureasindicateddirectlyon
tire of the accessory. Air pressure must be even on
bothsides.
INSPECTTHEACCESSORY
Make the following inspections with the accessory
attachedtothevehicle.Makesuretheelectricclutch
is disengaged the engine is shut off, the spark plug
wire is disconnect and all moving components are
completelystopped:
Parkvehicleandthe accessoryonalevelsurface is
restingonsolidsupports..
 Makesurethereisnothingundertheaccessory
thatshouldnotbethere.
 (tools,block,feet,hands,etc.)
 Check for and remove foreign objects wrapped
aroundbladespindles.
 Check for nicked, bent, broken, and worn cutting
blades.
 Replace or sharpen blades as required.
Referto“CutterBladeMaintenance”.
 Removesolidsupportsfromunderthedeckbefore
operating.
INSPECTWORKAREA
Makesuretheworkareacorrespondstotheintended
useofthisequipmentanditissafetoworkwithin.
Do not cut in wet conditions. Allow wet grass to
dry. Wet grass will clump and collect under the
mowingdeckcreatingpoordischargeandpremature
wear.Itwillalsorequireadditionalhorsepower.
WARNING
TOPREVENTINJURIES:
Clear area to be cut of debris and other unforeseen
removableobjectsbeforecutting.Markanypotential
hazards that cannot be removed such as tree
stumps, post, rocks, holes, and drop-offs with a
visibleflag.
WARNING
TOPREVENTINJURIES:
Do not operate accessory with loose hardware.
Loose hardware can result in a breakdown causing
seriousinjuryordeath.
WARNING
Loosebladescaneasilypiercea1/4’’steelplate.
Loosebladescanalsobethrownupto300feet.
TOPREVENTSERIOUSINJURIES,DEATHAND
MATERIALDAMAGE:
Periodically (and after a full day) disengage
ELECTRIC CLUTCH, shut down engine, remove
key,and:
 Checkforforeignobjectswrappedaroundtherotor
shaft.
 Lift and block the accessory before removing
objects.
 Frequently inspect accessoryfor anysign of wear
orlooseboltsandnuts(especiallythetheboltsfor
thestumpjumperandtheblade).
 TightenasindicatedintheTorquespecification
table.
 Makesureallguardsareinplaceatalltimes.
CAUTION
TOPREVENTINJURIES:
Do not exceed rated cutting capacity indicated (see
« INTENDEDUSE »section).
WARNING
TOPREVENTINJURIES:
Do not use accessory to lift or carry objects; to pull
fenceposts,stumpsorotherobjects;ortotowother
equipment. Doing so can damage the accessory,
causingseriousinjuryordeath.

Related product manuals