Mahindra BFMXTV60 - Adjusting the Cutting Height

18
ADJUSTMENTS
CUTTINGHEIGHTADJUSTMENT
Thereisapproximately4”ofheightadjustment.
Itisnotrequiredtodisconnectthesparkplugforthis
step,sinceitisdonefromthedriver’sseat.
Adjustthe height withthe knobfor theheightcontrol
onthecontrolbox.
Denseareasshouldbecutintwopasses.
MAXIMUM AND MINIMUM CUTTING HEIGHT
ADJUSTMENT
Use the other adjustment holes (item 1) on the
actuatorsupport.
Makesurethemowerdoesnotcomeintocontactwith
the wheels of the mower or any other component
afterdoingthisadjustment.
TOWHITCHOFFSET
Offset the mower to the opposite side of the
dischargechuteofthetowvehicle.
Itisrecommendedifthetowvehicleisequippedwith
a mid-mount mower to overlap the cut by
approximately 6”. This may vary depending on
terraintobemowed,obstacles,and/ortowvehicle.
Alwayskeepsafetyasthefirstpriority.
SeeStep3intheassemblysectionformoredetails.
Make sure the accessory's tow bar never comes
intocontactwiththewheelsonthevehicle.