Mahindra USA, Inc. All Rights Reserved.
23-1
23 Maintenance Procedures
23.1 Maintenance Tips and Precautions
Observe the following tips and precautions when performing
maintenance on the ROXOR.
• Always wear eye protection and gloves.
• Stay clear of rotating parts when engine is running.
• Stay clear of hot parts, before during and after maintenance.
• Avoid repeated contact with fluids.
• Do not allow fuel, coolant and other fluids to spill over electrical
and hot parts
• Before removing parts for maintenance, it is best to clean the
outer surface of the parts being replaced.
• Care must be taken when handling the air intake system
components. Never lift by using their hoses or pipes.
• Ensure that hoses and lines are oriented in their correct position
before tightening the clamps.
• Hoses and lines must not be subjected to any twists or stress.
• Ensure that all clips and supports are replaced.
• Never run the engine in an enclosed area. Exhaust contains
carbon monoxide which can cause loss of consciousness or
death in a very short time.
• Check to make sure the engine is off and parking brake set
before jacking up the vehicle.
• Never go under the vehicle while it is inclined without proper
bracing (approved jack stands).
23.2 Clean Spark Arrester
Do not perform service on the spark arrester while the system is
hot. Exhaust systems can reach extreme temperatures. Allow
components to cool sufficiently before proceeding. Remove any
combustible materials from around the spark arrester.
1. Place the transmission in Neutral and set the Parking Brake.
2. Remove the Retaining Screw and remove the Spark Arrestor
from the end of the Tailpipe. (Refer the below image)
Maintenance Procedures
To Next Page
Loading...
Need help?
General
