23-8
Mahindra USA, Inc. All Rights Reserved.
23.10 Check Transfer Case Oil Level and Leak Check
Before checking the transfer case oil, it should be warmed up by
driving the ROXOR for 10-15 minutes.
Only perform when the ROXOR is on level ground or support. Do
not use an impact wrench to remove the transfer case oil level
plugs. This may damage the threads in the transfer case resulting
in a leak.
1. Clean the transfer case oil level plugs and surrounding area.
(Refer to the below image)
2. Remove the transfer case oil level plug (upper) and check
whether oil is dripping out.
3. If oil is not dripping out, oil level must be below the required
level.
4. Add specified oil to bring it up to the level that it starts
dripping out.
5. Install and tighten the oil level plug.
23.11 Drain Fuel/ Water Separator
A Water-In-Fuel indicator light is provided in the multifunction
gauge on the dash panel. Follow the steps below to drain the fuel/
water separator and turn off the indicator light.
This device is located on the driver’s side of the engine bay, behind
the headlight and radiator support. (Refer to the below image)
1. Place a catch basin under the water/ fuel separator.
2. Turn the fuel drain petcock counter clockwise until water
begins to come out. (Refer to the below image)
Maintenance Procedures
To Next Page
Loading...
