Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
Procedure to diagnose concern of reverse gear lock
Step 1:
Confirm concern of gear lock in reverse gear or gear lever is not coming to neutral position.
After confirmation of the concern remove Transmission from the vehicle. Refer SOP.
Step 2:
Loosen the companion flange nut.
Remove nut, washer and companion flange from
transmission assembly carefully.
Take care that rear end oil seal is not getting
damaged.
Remove shift lever grommet, bottom shift lever
and plunger & retainer plate assembly.
Avoid using a steel hammer, as retainer plate is
made of cast iron and may break.
Step 4:
Remove Speedo sleeve and Speedo driven gear.
(As shown in figure)
To Next Page
Loading...
