Operation Manual
touchTymp MI 26
and
MI 36
Version
If there is not a high infection potential, MAICO recommends:
• Before cleaning always switch off and disconnect the device from power supply.
• For cleaning use a lightly dampened cloth with soap water solution.
• Disinfect the plastic housing of the touchTymp and its accessories by wiping the
surfaces with disinfectant wipes or a comparable product. Follow the
instructions on the specific disinfection product.
o Wipe before and after each patient
o After contamination
o After infectious patients
To avoid damage of the device and its accessories, please mind
the following:
• Do not autoclave or sterilize.
• Do not use the device in the presence of fluid that can come into
contact with any of the electronic components or wiring.
Should the user suspect fluids have contacted the system
components or accessories, the unit should not be used until
deemed safe by a MAICO certified service technician.
Do not use hard or pointed objects on the device or its accessories.
For more detailed cleaning recommendations see the following sections 3.3.2 to 3.5.
3.3.2 Cleaning the Touch Screen
Use a lens cleaning or microfiber cloth to clean the touchTymp touchscreen.
3.3.3 Cleaning the Case and Cables
Also, check-out our training videos:
MAICO Training | touchTymp Part 1 | 8/8 Cleaning - YouTube
https://www.youtube.com/watch?v=9o3QkyGCNLg&list=PLonI5JzuDcd7lxKobEy7BW3DS59QCsbA
G&index=8
Use caution while cleaning.
Use a damp cloth to clean the plastic parts of the touchTymp.
If disinfection is required, use a disinfectant wipe rather than a
spray product. Make sure that excess liquid from the wipe does
not seep into any sensitive areas such as connectors and
seams where plastic pieces connect such as the edges around
the touch screen.
Follow the instructions on the disinfection product.
To Next Page
Loading...
Need help?
General