9
Basic Operation
Instrucons Guide
Please note all (Ref.) refer to Page 1 Controls and Functions mapping guide.
Plug the connector into the back of the system labelled AC-
(Ref.) and the power supply into the mains.
Ensure the antenna (Ref.) is extended as far as possible so that
you can rotate it which will enable you to get the best signal you
can.
Switch the button on the rear of the unit to “On” (Ref.). Press
the ‘Power/Standby’ button to turn on the unit (Ref.). It will
automatically take you to DAB/DAB+ radio mode or the previous
mode you were using.
When DAB Radio is activated for the rst time the display will
show “Full Scan”, press the ‘OK’ button on the unit (Ref.) or the
‘Enter/Play’ button (Ref.) on the remote. The unit will then
scan and store all available stations.
To scroll through the stations use the ‘Previous’ (Ref.) and ‘Next’
buttons (Ref.). Press ‘OK’ (Ref.) to listen to a station.
To change the mode, press the ‘Mode’ button (Ref.) on the unit
to switch between the options. You can also select your option
on the remote (Ref.).
To Next Page
Loading...
Need help?
General
