Press the ‘Standby/Mode’ button (Ref.1) multiple times to
switch between DAB and FM. The rst time you do this, the FM
frequency “87.5 MHz” will be displayed on the screen.
Fully extend the antenna (Ref.14).
To scan for the available stations with good signal, press and
release the ‘Scan/Snooze’ button (Ref.2) for the radio to begin
scanning up the frequency band. The next available station will
then begin to play.
To scan down the frequency band, press and hold the ‘Scan/
Snooze’ button (Ref.2) for a few seconds.
The radio will display station information when you press the
‘Info/Menu’ button (Ref.4). Press multiple times to view all
information available (See page 11).
To tune a specic frequency manually
To listen to a specic frequency use the ‘Previous’ or ‘Next’
buttons (Ref.5/6) to search forward or back.
Instrucons Guide
When you are listening to a DAB/DAB+ radio station with good
signal, you can press the ‘Info/Menu’ button (Ref.4) repeatedly to
show the dierent programme information.
Signal Strength: Displays a signal bar with the strength of the
current station.
Bit Error Rate: Provides details of the signal error rate.
Channel and Frequency: Displays the station’s transmission
channel number and frequency.
PTY (Programme Type): Shows the type and description of the
program provided by the DAB station.
Time and Date: Displays the time and date information
provided by the broadcaster.
Bit Rate: The data rate which the signal is being transmitted.
DAB indication: Indicates DAB mode.
Dynamic Label Segment (DLS): Displays scrolling text
information supplied by the broadcaster.
Station Information for DAB Radio
Instrucons Guide
To Next Page
Loading...
Need help?
General