Makeblock mBot2 - The mBot2 Vehicle; mBot2 Documentation; CyberPi Firmware Update

2 | P a g e
Content and Challenges
Section
Content
A
The mBot2 Vehicle
B
Introduction and Setup
C
Our First Program – Hello
D
Push the Buttons
E
Run the Motors
F
Avoid or Seek
G
Detect and Follow a Line
H
SumoBot
I
Connect Servos, Sensors and Motors
Appendix 1
CyberPi Extras
Documentation
https://www.yuque.com/makeblock-help-center-en/mblock-5
CyberPi Blocks https://www.yuque.com/makeblock-help-center-en/cyberpi
(including Pocket Shield, mBot2 Shield and mBuild Modules)
Firmware Update
To update the CyberPi firmware:
1. Open the online ide at https://ide.mblock.cc/#/
2. Click on Devices and add the CyberPi device to the list, if it is not there already
3. Click Connect and connect the CyberPi (download and install the device driver, if asked)
4. Click on Settings and select Firmware Update