MakerBot Replicator Mini+ - Setup Kit Contents

GETTING STARTED 9
When you set up your MakerBot Replicator Mini+ 3D Printer, remember that it was built and packaged very
carefully at the MakerBot factory. We hope you’ll take your time and be just as careful unpacking it and
getting it set up.
POWER CORD
USB A-TO-B CABLE
1 1
1
MAKERBOT PRODUCT SAFETY
INFORMATION BOOKLET
SMART EXTRUDER+
1
SETUP KIT
SMALL MAKERBOT PLA
FILAMENT SPOOL
1