GETTING STARTED 10
UNPACKING THE REPLICATOR MINI+
Open the Box
Open the box containing your MakerBot Replicator
Mini+ and remove the setup kit.
Remove Securing Tape And Build Platform Foam
Be careful in removing tape that holds on that secures
the build plate to the z-stage. Remove the foam under
the build platform.
Remove Shipping Clips
Remove the clip that prevents the build platform
from moving during shipping. Also, remove the two
clips attached to the gantry belts. Save these clips!
They will be handy if you ever need to transport your
MakerBot Replicator Mini+ in the future.
To Next Page
Loading...
