MakerBot Replicator Guide

1
MakerBot Replicator 5th Generation Teardown Guide
MakerBot
Tools Needed:
1.3mm Hex Driver
T10 - T20 Torx Driver
Phillips Screw Driver
2.0mm Hex Driver
1.5mm Hex Driver
2.5mm Hex Driver
T10 Security Torx Drive
1 Pair of thin Tweezers
Small Container for Screws
Small Wire Cutters

MakerBot Replicator Specifications

General

Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Print Technology	Fused Deposition Modeling (FDM)
Layer Resolution	100 microns
Connectivity	USB, Wi-Fi
Supported Materials	PLA
Display	LCD display