2
MakerBot Replicator
MakerBot
Step 2 - Remove Filament
Spool Drawer
Gently lift the Top Cover about
2 inches in order to give enough
clearance for the Filament Spool
Drawer Stop to pass through.
Gently lift the Filament Spool
Drawer upward to remove from
the body of the Replicator.
Step 1 - Remove the Back Panel
Six (6) Torx socket head screws
Six (6) Torx Button Head bolts
Four (4) Torx socket head screws
surrounding Power Supply
Remove the following screws from
the outer edge of the Back Panel
using a T15 screw driver:
Gently pull back the Back Panel
o. Be mindful of the two tabs in
the back if they need to be
popped out.
NOTE: Four (4) screws at the top
center of the Back Panel do not
need to be removed).
•
•
•
•
•
To Next Page
Loading...
