B
A
C
2000
1750
1500
1250
1000
750
500
250
False clamp plate:
A clamp plate (A) is fitted to the machine to
prevent pressure marks on sensitive material.
LED
V
illuminates.
To dismount:
•
Remove the clamp plate (A) by turning the
screwdriver (found in tool box) in the space
between the clamp and clamp plate.
•
Store the clamp plate in the provided holder
(C) LED
V
deletes.
The remaining cut, without false clamp, is
20 mm
Warning!
Make sure the false clamp is in the
provided holder otherwise the
measurement from 20 mm - 89 mm cannot
be cut.
To mount:
•
The clamp plate (A) is inserted to the top into
the clamp (D).
The remaining cut, with false clamp, is
90 mm
•
Operation
•
Airtable:
It is easier to position large stacks of paper
when the airtable
I
is switched on.
Setting clamping pressure:
The clamp pressure can be adjusted using the
adjustment knob
G
. The clamping pressure can
be read on the light panel
S.
To Next Page
Loading...
