Making Memories Slice - BASIC OPERATIONS; STEP 1 Charging the Slice; STEP 2 Prepping the cutting mat

To Next Page

To Previous Page

ENGLISH

BASIC OPERATIONS

STEP 1

Charging the Slice™

To charge the Slice™ Cordless Design Cutter™:

1. Plug the power adapter into the Slice™, as shown below.

2. Plug the power cord into a grounded electrical outlet.

3. Leave the Slice™ plugged in for approximately 1 hour to fully charge it.

Note: You can also use the Slice™ while it is plugged in, if desired.

STEP 2

Prepping the cutting mat

To prep the cutting mat:

1. Apply a line of repositionable adhesive on one end of the glass mat.

2. Spread thin coat evenly across the glass mat with a foam brush, until it coats

the mat completely, as shown below.

3. Allow the adhesive to dry for at least 2 minutes.

Note: The adhesive remains white while it is wet and becomes clear once it is dry.

Note: Make sure the adhesive has dried properly before placing the paper on the cutting mat.

Tip: Before applying a new coat of repositionable adhesive, ensure the mat is clean and old

adhesive has been removed (see Basic Care p.18).

Step 1 Step 2