___
Reparaturanleitung PS-4600 / PS-5000 26
Repair manual DCS3500 / DCS3501 / DCS4300 / DCS4301 / EA3500F / EA3501F / EA4300F / EA4301F / MEA3500L / MEA3500M / MEA4300G / MEA4300L
Removing the cylinder and piston
Disconnect the intake and exhaust sides.
Unscrew the spark plug.
Remove the ignition armature.
Disassemble the vibration damper between
the cylinder and front grip.
Unscrew 4 screws 4 and pull the cylinder up
and off.
Note: After pulling off the cylinder 6, support
the piston with the assembly tool (
chap. 00
pos. 6
).
Remove spring ring 5 with needle-nose pliers.
Assembling the cylinder and piston
Use a new gasket!
Note: The protuberance on the gasket must
point towards the induction side.
Before assembly, lightly oil the cylinder race
and piston!
Push assembly tool 7 under the piston.
Turn the opening on the piston ring towards the
piston ring lock.
Use the piston ring tensioner 8 to press the
piston ring together.
Push the cylinder onto the piston. Let the piston
ring tensioner slide down with it.
Remove the assembly tool and piston ring
tensioner and press the cylinder all the way
down.
Hand-tighten the screws 4 lightly crosswise,
and then tighten to the correct torque, again
crosswise.
To Next Page
Loading...
Need help?
General
