What to do if Makita Trimmer has abnormal vibration?
If your Makita Trimmer is vibrating abnormally, it could be due to a broken nylon cord. Try tapping the nylon cutting head against the ground while it is rotating to feed the cord. If the issue persists, the drive system may not be working correctly.
Why Makita Trimmer does not reach maximum RPM?
If your Makita Trimmer does not reach maximum RPM, consider the following: * Improper battery installation: Install the battery cartridge as described in the manual. * Dropping battery power: Recharge the battery, and if that's ineffective, replace it. * Faulty drive system: Seek repair from your local authorized service center.
What to do if my Makita DUR190L motor does not run?
If the motor of your Makita Trimmer doesn't start, possible causes include: the battery cartridge might not be installed—ensure it is properly installed. The battery may be under voltage—try recharging it, and if that doesn't work, replace the battery. If these steps don't resolve the issue, the drive system may not be working correctly.
Why does my Makita DUR190L Trimmer motor stop running after a little use?
If your Makita Trimmer motor stops shortly after starting, it could be due to a low battery charge—recharge the battery, and replace it if recharging isn't effective. Another cause might be overheating—stop using the tool and allow it to cool down.
Details noise emission levels measured for different cutting tools and models.
Specifies necessary gear to protect the operator during use.
Outlines precautions for the operating environment to prevent accidents.
Details safety measures related to power sources and battery handling.
Steps for changing the cutting line on the nylon cutting head.
To Next Page
General
