19
Procut 2600TC & 3000TC — User Manual
Main Gearbox lubrication
Oil to be changed after first 50 operating hours
then every 600 hours and/or annually used under
normal operating conditions. Use SAE 90 (EP)
gear oil or equivalent. Oil level to be checked after
every 40 operating hours. Check oil level in the
gearbox by removing the oil fill plug and checking
the dipstick, if level is below line on dipstick add
oil. To drain the oil from the gearbox remove drain
plug on underside of gearbox. (Oil quantity ap-
prox. 2.2Ltr)
Swivel Gearbox lubrication
Oil to be changed after first 50 operating hours
then every 600 hours and/or annually used under
normal operating conditions. Use SAE 90 (EP)
gear oil or equivalent. Oil level to be checked after
every 40 operating hours. Oil level in the gearbox
to be level with oil level hole. To drain the oil from
the gearbox remove drain plug. (Oil quantity ap-
prox. - 1.5Ltr top, 1.2Ltr lower).
Accumulator
The mower has been installed with a hydraulic accumulator to act like a soft ride for
the cutter bed unit during road transportation and drops rams 25mm to allow to float.
If the transport of the mower seems to be more severe on the unit during transport,
get a qualified person to check the condition of the accumulator or get it recharged.
The pre-charge pressure in the accumulator is set at 35 Bar.
To Next Page
Loading...