Malvern Instruments ZETASIZER - Page 22

Site requirements
20
The mains power supply must be clean and filtered. If necessary, fit an Uninterruptible
Power Supply (UPS) to remove any spikes or noise. The power requirement for each com-
ponent of the NanoSampler system is given below.
Component Power requirement Power sockets required
NanoSampler
Mains supply:95 - 240 Vac
+/-10%, 50-60Hz
1
External PSU
External PSU:100-240Vac
47/63Hz 3.2A, O/P:
40.8Vdc 3.18A
1
Computer
See manufacturer’s doc-
umentation
1
Computer Monitor
See manufacturer’s doc-
umentation
1
Computer specification and usage
Note:The NanoSampler requires the installation of Zetasizer 7.10 software or
later.
Contact the Malvern Helpdesk or website for the recommended computer specification;
otherwise consult the Software Update Notification document supplied on the soft-
ware CD.
The NanoSampler data can be stored on a network but this is not recommended. Also,
running other software at the same time may reduce its speed.