Malyan MA10 Mini - Setting Nozzle and Bed Temperatures; Filament Loading

Rotating the control wheel clockwise to move the highlight to Nozzle and press
the center of control wheel to enter the menu, Rotating the control wheel to set
the temperature of the nozzle to your target value, it depends on the lament you
plan to use. After you set up your target value, press the center of control wheel
Using the same procedure, set the Bed temperature to the target temperature
for your lament type.
Rotating the control wheel counterclockwise to move the highlight to Control,
press the center of control wheel to back to the previous menu.
While the printer is heating, open your lament. Using a pair of scissors or side
cutters, diagonally snip the end of the lament to make a point, as shown in the
images below.
Place the lament reel on the lament rack
on the left side of the printer.
While squeezing the lever on the Feed
Mechanism, insert the lament and push it into
opening. Keep pushing until you feel
resistance as it hits the extruder. Release the
lever on the Feed Mechanism.
10
9.
10.
11.
12.
13.
14.