11
12
13
Removing and fitting vibration damper,
replacing front crankshaft gasket
70
Fitting vibration damper
Fig. 11
Position vibration damper with driver flange; note
the position of the scale disc relative to the cranks-
haft as you do so!
Tighten the securing bolts with the prescribed tor-
que.
Fig. 12
Screw on delivery start indicator.
Tensioning V-belt
Fig. 13
Therefore check whether the scale of degrees on
the inspection hole cover of the flywheel housing
and on the vibration damper indicate the same va-
lues.
If necessary readjust delivery start indicator.
To Next Page
Loading...
