Man D2848 LE201 - Filling Coolant

Installation and Commissioning
MAN Industrial Diesel Engines D2848/40/42 LE201/203/211/213
40
Carefully read the Operating Instructions before starting any work!
This is especially valid for the chapter on General Safety Instructions
and the safety instructions in each of the chapters.
6.4.2 Filling Coolant
NOTE!
Do not let coolant drip or leak out while filling. Do not let coolant leak out onto the ground or
into bodies of water. Otherwise, the environment will be damaged.
Fill the cooling system of the engine with a mixture of tap water and ethylene glycol antifreeze agent or an
ticorrosion agent.
Only use approved fluids and lubricants (see “Fluids and Lubricants ..." publication).
1. Remove cap (1).
2. Slowly fill in coolant up to the lower edge of the
filler neck.
For coolant filling capacity, see “Technical Data”
page 82.
3. Reinstall cap (1).
1