M&B AED7000 - CPR Protocol and Emergency Cancellation

To Next Page

To Previous Page

Deliver a shock:

To deliver a shock, the several steps below must be obeyed:

Make sure the indicator of shock button is flashing, which means the AED7000 is

properly charged.

Before pressing the shock button, make sure no one is touching the body of the

patient.

Press the shock button.

Note

If the shock button is pressed, shock indicators and

analyzing indicator will stop flickering while the

flickering of Caution indicator will continue.

Prior to pressing the shock button, if the AED7000 detects that

the pads are not firmly placed on the chest of the patient the

following alert will occur

Shock cancelled, check the electrodes.

If the operator does not press the shock button, the AED7000 will

automatically begin internal discharging procedure in 30 seconds.

Time out, analysis restart.

5.8 Cardiopulmonary resuscitation procedure (CPR)

The AED7000 will enter cardiopulmonary resuscitation procedure, when the

condition below occurs:

Note

During the CPR procedure, the four indicators: Check