18 CG-2 | 1.04.00 www.mc-techgroup.com
11 RECEIVING THE CG…
The CG... converter is a completely pre-installed unit. The standard catalyst cartridge supplied is already
installed.
• Remove the CG... converter and any accessories carefully from the transport packaging immediately
after arrival and check the contents of the delivery against the delivery note;
• Check the goods for any transport damage and - if necessary - inform your transport insurer imme-
diately of any damage.
12 STORAGE
Cartridges should not be stored for more than 1 year. Storage must be vibration-free and dry.
13 INSTALLATION INSTRUCTIONS
The converter housing of the versions CG-2 and CG-2M is designed as a 19" unit and is also suitable
for wall-mounting or mounting plate by using a special mounting bracket. The versions CG-2H-W and
CG-2MH-W are executed as wall mounting housing.
Because of the system of protection IP 20 (EN60529) the converter has to be
built into a protective cabinet respectively housing. When mounting outdoors,
the converter must be installed in a protective housing, frost-free in winter and
adequately ventilated in summer. Direct sunlight is to be avoided.
In order to avoid the re-oxidation of NO to NO
2
in long sample lines, the con-
verter must be mounted in the immediate vicinity of the gas-analyser if possi-
ble.
The converter should be installed away from sources of heat and in a position
which allows air to circulate freely in order to avoid any heat accumulation.
To avoid a heating-up of other devices in case of a 19”-rack, we recommend a
minimum mounting height of 4U.
To Next Page
Loading...
