V.033114
20 M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
can record the production levels and use this
information to estimate future production times for
this particular job.
Press the Back Arrow to return to the MENU
screen.
Press the Timers button on the Menu screen. The
Timers menu contains five menu items: Index,
Flash, Quartz, Delay and Preheat.
Index dwell time is the time interval during
automatic operation in which the system operator
may load and/or unload garments. This time
interval starts after the index table has reached the
fully raised position at the conclusion of the index
motion, and ends with the start of the index table
start cycle.
To quickly adjust the time in 0.5 second
increments, press the plus or minus buttons.
To adjust the Index dwell time, press the data
entry cell to the right of Index; a numeric keypad is
displayed. Enter the dwell time in seconds and
then press Enter. The maximum Index dwell time
interval is 20 seconds and the minimum is 0
seconds.
Flash controls the dwell time of the index table in
the raised position (Flash Cure position). To adjust
the Flash dwell time press the data entry cell to
the right of Flash; a numeric keypad is displayed.
Enter the time in seconds and then press Enter.
The maximum Flash dwell time is 20 seconds and
the minimum is 0 seconds.
To quickly adjust the time in 0.5 second
increments, press the plus or minus buttons.
Quartz controls the dwell time of the index table in
the raised position (Flash Cure position). To adjust
the Quartz dwell time press the data entry cell to
the right of Quartz; a numeric keypad is displayed.
Enter the time in seconds and then press Enter.
The maximum Quartz time is 15 seconds and the
minimum is 0 seconds.
To quickly adjust the time in 0.5 second
increments, press the plus or minus buttons.
To Next Page
Loading...
