V.033114
M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA 21
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
Delay controls the dwell time of the quartz lamps
as the index table starts its index motion. This
additional delay time allows the quartz lamps to
reach operating power and reduces overexposure
of heat sensitive substrates. To adjust the Delay,
press the data entry cell to the right of Delay; a
numeric keypad is displayed. Enter the time in
seconds and then press Enter. The maximum
Delay time is 5 seconds and the minimum is 0
seconds.
To quickly adjust the time in 0.5 second
increments, press the plus or minus buttons.
Preheat controls the preheat time interval for the
Quartz Flash panels. Press the data entry cell to
the right of Preheat; a numeric keypad is
displayed. Enter the Preheat time in seconds and
then press Enter. The maximum Preheat time is
15 seconds and the minimum is 0 seconds.
Note: Always use preheat before starting an automatic
print cycle. This allows the quartz lamps sufficient
time to achieve curing temperature and eliminates
under cure and/or ink build-up on screens.
From the Menu screen press the Options button.
The Options menu is used to access the optional
control features which may have been supplied
with your press. The options listed are Heads,
Machine, Revolver, Servo, Megastamp,
Flocker, Flashes and Glue. To access any of
these optional control features press the button for
that specific control option.
Press the Back Arrow to return to the Menu
screen.
Heads selects print heads to double print or multi-
print up to a maximum of 9 prints. The Heads
menu also includes menus used to control the
optional M&R Ink Dip feature (U.S. Patent No.
5,649,479).
To access the Heads menu, press the Heads
button in the Options menu.
To Next Page
Loading...
