V.033114
24 M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
In the Enhanced mode, the print stations may be
On or Off. Pressing the PRINT button momentarily
on the main control panel or at any of the print
station control panels commands the index
carousel to move up to the upper (print) position.
When the PRINT button is pressed and held for 2-
3 seconds, the print station performs a complete
print cycle, (flood, index table up, print, index table
down). The Enhanced mode eliminates the need
to turn Off print stations when performing set up
operation. To select either Standard or Enhanced
mode, press the button to the right of Head Setup.
Each time you press the button, the selection
changes between Standard and Enhanced.
Each print station has a PRINT button located on
both the main operator control panel and each
individual print station control panel. The PRINT
button is used to raise the print carousel during
setup operations and to command individual print
stations to perform one complete flood/print cycle.
To turn on the Setup Mode menu selection, press
the OFF button to the right to the right of Setup
Mode. The indication changes to ON.
Setup Mode
ON
Print Station
(Single/Multi
Switch) OFF
Setup Mode ON
Print Station
(Single/Multi
Switch) ON
In this mode, pressing the PRINT button once
commands the print table to lift. Pressing the
PRINT button a second time commands the print
carriage to chop down to the print position.
Pressing the PRINT button a third time commands
the index table to return to the down position and
the print carriage to chop back up to the Flood
position.
In this mode, pressing the PRINT button results in
one complete flood, table up, print and table down
cycle. You must have the selected print station
Single/Multi switch in the Single or Multi position
on the main control panel.
Skip Print –
(U.S. Patent No.
5,383,400)
This control menu allows the system operator to
select either No T-Shirt Sensor (No Shirt Detector
(U.S. Patent No. 5,383,400) or Foot Pedal/Push
Button to skip pallets which do not have a
garment loaded on them. To change from No T-
Shirt Sensor to Foot Pedal/Push Button press
the button labeled No T-Shirt Sensor. The button
displays Foot Pedal/Push Button. Each time you
press the button it changes between No T-Shirt
Sensor and Foot Pedal/Push Button.
To Next Page
Loading...
