V.033114
M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA 23
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
Inkdip Every
(US Patent No.
5,649,479)
The Inkdip Every control automatically scoops ink
from the rear ink well area of the screen into the
active image area of the screen. Press the data
entry cell to the right of Inkdip Every; a numeric
keypad is displayed. Enter the number of print
cycles before the ink dip control feature activates
and then press Enter.
If you enter the number 10, the Inkdip Every
automatically retrieves ink from the ink well area of
the screen after 10 print cycles have been
completed. The maximum value is 999. If you
enter 0, the Inkdip Every control will not operate.
Inkdip Time controls the distance that the print
carriage moves back into the ink well area. The
maximum time is 1.7 seconds and the minimum is
0.30 seconds. Press the data entry cell to the right
of Inkdip Time; a numeric keypad is displayed.
Enter the Inkdip Time in seconds and then press
Enter.
To access the Machine menu, press the Machine
button on the Options menu.
The first menu selection in the Machine menu is
Head Setup. Each print station has a PRINT
button located on both the main operator control
panel and each individual print station control
panel. The PRINT button may be set to operate in
Standard or Enhanced mode using this menu
selection.
Note: To use the PRINT button in Standard mode, first
make sure all print stations are in the OFF
position on the main control panel.
In the Standard mode, pressing the PRINT button
moves the print carousel up to the print position
and commands the print station to perform one
complete flood/print cycle.
To Next Page
Loading...
