V.033114
26 M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
Print Head
Program
Indicators
Located just below the Revolution number menu
item is a reference line listing each of the print
heads. Below each of the numbers is a letter or
number that indicates how the print head will
perform in a given revolution in the Revolver
Program.
The indicators used are F indicating the head will
be used as a flash cure station, a dash ( - ) which
indicates the print head is not used in this
revolution or a number for single, double or multi-
print.
Note: To program print heads for flash cure or
single/double, multi-print operation you must refer
to the instructions on how to program these
functions.
Job No. assigns a job number from 1 to 3 for a set
of Revolver program parameters saved in the PLC
memory. Press the data entry cell to the right of
Job No; a numeric keypad is displayed. Press the
numbers, from 1 to 3, and then press Enter.
Job Clear clears all current Revolver program
data for a saved Job No. from the PLC. To use it,
press the Job Clear button when the Job No. to
be cleared is displayed in the Job No. data entry
cell.
The Index Delay is used the same way as the
Index dwell timer described previously. To
operate the Index Delay, press the Off button to
the right of Index Delay. The indication will
change to On and the Index Delay will be
activated based on the Index Dwell Time as
selected in the Timers menu.
Press the Back Arrow to return to the Options
screen.
To Next Page
Loading...
