V.033114
M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA 27
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
Alarm Enabled provides the system operator with
a way to either enable or disable the audible
alarm signal which sounds just before the
completion of a programmed Revolver print
sequence. Press the button to change between
Alarm Enabled and Alarm Disabled.
The Stop Alarm button is used to silence the
audible alarm signal that sounds just before the
completion of a programmed Revolver print
sequence. Press the Stop Alarm button to turn off
the audible signal.
To access the Servo menu press the Servo
button on the Options menu.
The Index Servo Option menu includes four
menu selections: Rotation, Index, Servo Offset
and Pallet Size.
Rotation selects the index rotation direction;
clockwise (CW) or counterclockwise (CCW). To
select the index rotation, press the button to the
right of Rotation. Each time you press the button,
the indication changes between CW and CCW.
The number of index cycles may be selected to
either Single index, or Double index. When
Single is selected, the indexer performs one index
cycle and all active print heads complete a
flood/print cycle. When Double index is selected
the indexer performs two complete index cycles
and all active print heads complete a flood/print
cycle. To select the Single, press the button to the
right of Index until 1 is displayed. To select the
Double, press the button until 2 is displayed.
To Next Page
Loading...
