The Servo Offset sets the stopping position of the
indexer servo drive as it aligns with the index
registration forks. Servo Offset also adjusts the
index stop after changing pallets to a smaller or
larger size. Larger pallets increase the index load,
while smaller lighter pallets decrease the index
load. As a result, changing of printing pallets can
have an effect on the stopping position and the
efficient operation of the index servo drive.
The range of the setting is from -0.26” to +0.26”.
To change the Servo Offset setting for either End
Position or Start Position press the − button to
decrease the setting or button to increase the
setting.
The next menu selection is Pallet Size: Small,
Normal or Ex-Large. To select a pallet size, press
the button which represents the pallet size you
require.
As you press the button, the pallet size is
displayed.
IMPORTANT: Selecting an incorrect pallet size
may result in damage to the machine. Damaged
caused by such misuse will not be covered under
the Limited Warranty.
Press the Forward Arrow to access additional
Index Servo Options.
The press includes an automatic lubrication
system for the servo index drive system.
The lubrication system automatically dispenses
lubricant to the servo index drive system based on
the number of cycles entered. We recommend that
the setting be adjusted for every 30 index cycles.
Press the data entry cell to the right of Run Oiler
Every; a numeric keypad is displayed. Enter a
number from 1 to 99 and then press Enter.
Index is a non-adjustable indicator of how many
index cycles remain before automatic lubrication.
Manual Oiler button activates the lubricant pump
resulting in the manual lubrication of the servo
index drive system. To activate the Manual Oiler,
press the button to the right of Manual Oiler. The
button changes to On. After activation of the
pump, the indication automatically changes back
to OFF.
To Next Page
Loading...
