V.033114
M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA 33
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
Quartz controls the time the Quartz Flash heating
elements are on. To adjust the Quartz dwell time,
press the data entry cell to the right of Quartz; a
numeric keypad is displayed. Enter the time in
seconds and then press Enter. The maximum
Quartz Time is 15 seconds and the minimum is 0
seconds.
A graduated scale provides a visual indicator of
the balance of Quartz Time. If the Quartz time is
set for 15 seconds, the graduated scale displays a
solid green line up to the 15 indicator. As the
Quartz Time counts down the green line retracts
towards the zero indication and the data entry cell
displays the remaining Quartz Time. When the
Quartz Time reaches zero, the Quartz heating
elements turn Off.
To select a print head to operate as a quartz flash
cure station, first place the FRONT/REAR switch
for that particular print head on the main control
panel in the FRONT position. Now press the Enter
button to the right of Quartz.
Press the print station number to operate as a
quartz flash cure station. After you press the print
station number the indication changes to green
and displays a vertical line for On. If you press the
print station number again, the indication changes
back to red and displays a zero for Off.
To select any print station to operate as a Quartz
Flash station, press the In Any Head button.
Press the Back Arrow button in the lower right
corner to return to the previous screen. The gray
indicator below the print head on the screen now
displays a letter Q confirming that the print head
will now operate as a quartz flash cure station.
Press the Back Arrow to return to the previous
screen.
To Next Page
Loading...
