V.033114
32 M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
Flashes is used to designate infrared flash
position. To access the Flashes menu, press the
Flashes button on the Options menu screen.
Flashes selects the print head location where a
flash unit will operate in the print flash sequence.
To select a print head to operate as a flash cure
station, first place the FRONT/REAR switch for
that particular print head on the main control panel
in the FRONT position. Press the Enter button.
The indicator below the print head on the screen
displays a letter F confirming that the print head
will now operate as a flash cure station.
Infrared flash cure only. Flash Time controls
the dwell time of the index table in the raised or
flash cure position. To adjust the Flash Time,
press the data entry cell to the right of Flash
Time; a numeric keypad is displayed. Enter the
dwell time in seconds and then press Enter. The
maximum Flash Time is 20 seconds and the
minimum is 0 seconds.
A graduated scale serves as a visual indicator for
the balance of Flash Time. If the Flash Time is
set for 20 seconds, the graduated scale displays
a solid red line up to the 20 indicator. As the
Flash Time counts down the red line retracts
towards the zero indicator and the data entry cell
displays the remaining Flash Time. When the
Flash Time reaches zero, the Flash heating
elements retract.
To Next Page
Loading...
