V.033114
36 M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
right of Spray Every; a numeric keypad is
displayed. Enter the number from 1 to 99 and then
press Enter. Your selection for Spray Every is
now displayed in the data entry cell.
Front Delay permits the system operator to
program a time delay interval, in hundreds of a
second, before activation of the Annamister
system. The maximum setting is 1 second and the
minimum setting is 0.01 second. This setting will
vary depending on the pallet size and press
speed. However in most cases this setting will be
less than 0.1 second.
To enter a number for the Front Delay, press the
data entry cell to the right of Front Delay; a
numeric keypad is displayed. Enter the number
from 0.01 to 1 and then press Enter. Your
selection for Front Delay is displayed in the data
entry cell.
Front Duration permits the operator to program
the time interval, in hundreds of a second, in which
the M&R Annamister applies adhesive to the
pallets. The minimum setting is 0 and the
maximum setting is 1 second. This setting varies
depending on the surface area (size) of the pallet
and the press speed. In most cases the setting is
set between 0.2 and 0.4 seconds.
To enter a number for the Front Duration, press
the data entry cell to the right of Front Duration; a
numeric keypad is displayed. Enter the number
from 0.2 to 0.41 and then press Enter. Your
selection for Front Duration is displayed in the
data entry cell.
Rear Delay (5)
Rear Duration
(6)
Rear Delay operates in the same manner as
described for Front Delay.
The Rear Duration operates like the Front
Duration.
Note: Rear Delay and Rear Duration will not be
displayed if the Revolver Flash is activated in the
Service Data menu. Contact M&R Technical
Support for assistance in accessing these control
menus.
To Next Page
Loading...
