M&R Challenger 2 - Hardware Test; Panel Test

V.033114
38 M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
Hardware Test
The HARDWARE TEST screen includes the test
menus: PANEL TEST, PROX TEST, OTHER
TESTS, INDEX MOTION, INDEX SERVO and
INDEX SERVO HISTORY.
Panel Test
The PANEL TEST screen provides a visual
indication of all the switches used on the main
control panel. The indications confirm the correct
operation and position of the particular switch or
push button.
On the PANEL TEST screen the PRINT buttons
are located under the print head number.
If you activate any of the PRINT buttons on the
main control panel the gray color changes to blue,
indicating that the print button is operating
correctly.
The next row of switches is the SINGLE/MULTI
switches on the main control panel.
The SINGLE/MULTI switches are shown in the
middle or OFF position on the PANEL TEST
screen. To test any of the switches, place the
switch in the SINGLE position. The switch on the
screen moves to the SINGLE position and the
color changes to green. If you place the switch in
the MULTI position the switch on the screen
moves to the MULTI position and the switch color
changes to orange.
If you place the switch in either SINGLE or MULTI
position and the switch does not change position
as described, then the switch must be considered
faulty and should be inspected or replaced.