M&R Challenger 2 - Page 39

V.033114
M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA 39
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
Front/Rear
Switches
The next row of switches is the FRONT/REAR
switches. The FRONT/REAR switches are shown
in the REAR position on the PANEL TEST screen.
To test any of the switches place the switch in the
FRONT position. The switch on the screen moves
to the FRONT position and the color changes to
red. If you place the switch in the REAR position
the switch on the screen moves to the REAR
position and the color changes to gray.
If you place the switch in either FRONT or REAR
position and the switch does not change positions
as described, then the switch must be considered
faulty and should be inspected or replaced.
Test Print On/Off
Switch (1)
The TEST PRINT ON/OFF switch is shown in the
OFF position on the PANEL TEST screen. To test
the switch, place the switch in the TEST PRINT ON
position. The switch on the screen moves to the
TEST PRINT ON position. If you place the switch in
the TEST PRINT OFF position, the switch on the
screen moves to the TEST PRINT OFF position. If
you place the switch in either TEST PRINT ON or
TEST PRINT OFF position and the switch does not
change position as described, then the switch must
be considered faulty and should be inspected or
replaced.
Print Start/Print
Finish Switch
(2)
The PRINT START/PRINT FINISH switch is
shown in the middle or OFF position on the
PANEL TEST screen. To test the switch, place the
switch in the PRINT START position. The switch
on the screen moves to the PRINT START
position. If you place the switch in the PRINT
FINISH position, the switch on the screen moves
to the PRINT FINISH position. If you place the
switch in either PRINT START or PRINT FINISH
position and the switch does not change position
on the screen, then the switch must be considered
faulty and should be inspected or replaced.
Automatic/
Manual Switch
(3)
The AUTOMATIC/MANUAL mode switch is
shown in the middle or OFF position on the
PANEL TEST screen. To test the switch, place
the switch in the AUTOMATIC position. The
switch on the screen moves to the Automatic
position. If you place the switch in the MANUAL
position the switch on the screen moves to the
MANUAL position. If you place the switch in either
AUTOMATIC or MANUAL position and the switch
does not change position as described, then the
switch must be considered faulty and should be
inspected or replaced.