You are now ready to print.
Place the Automatic/Manual switch (10) in the
Automatic position. Activate the Print Start
switch (9) to begin the Revolver sequence.
To continue printing: When you hear the audible
alarm near the end of the last revolution push the
Print Start switch (9). Also make sure the Index
Delay setting under Timers is set to a long
enough time for you to unload/load the shirts.
Example: If you have the Flash Time set for 4
seconds and the Index Dwell Time set for 8
seconds, when you Print Start the press, the
pallets will remain up for 4 seconds, the flash will
come out and the tables will drop and wait an
additional 4 seconds before indexing until you
have all of the pallets loaded.
The press will then switch to the Flash Only time
of 4 seconds for all of the revolutions you have
programmed. As the press approaches the end of
the last revolution and the audible alarm sounds.
Press Print Start. The press returns to the Flash
and Index time combination to give the operator
time to unload and load the garments.
The last shirt/pallet will stop at the load station.
To Next Page
Loading...
