2 - 27
PROCEDURE OF FREE WHEELING
The platform may only be towed a short distance and only by a machine with
significant braking performance, in order to hold it: the two machines must be
connected by a tow bar.
- To set the platform to free wheel, it must not be subject to any
translation stresses from slopes. The wheels must be able to turn
freely.
- If possible, raise the platform to free the drive wheels in order to
facilitate the operation.
- Loosen bolt 1 (Fig. E) on each wheel 22 mm from the edge, up to
the resistance point, without forcing it (20 Nm) : see (Fig. F).
- The machine can be towed as a trailer.
Warning: do not loosen the bolt more than 22 mm, otherwise it may break
RE-INSTALLATION
-
Turn the wheel gently from left to right to reset the gear while
retightening the screws (1) (Fig. E). Pay attention to the torque
when tightening (150 Nm).
To Next Page
Loading...
