3 - 13
3 - 13
D7 - CHECK THE TIGHTNESS OF THE BOLTS ON THE
TURRET'S MOTOR
Set the platform on a horizontal surface.
- Check the tightness of the nine bolts 1 (Fig. D7/1).
- The tightening torque for the bolts is 8 daN.m ± 10%.
- 1 daN = 1 Kg
D8 - DRAIN THE TURRET'S GEAR MOTOR REDUCTION
BRAKE
Set the platform on a horizontal surface.
- Remove the turret's left cover.
- The gear motor is revealed with the valve block facing to the back.
- Remove the filling-breather cap 2 (Fig. D7/1) to ensure good drainage.
- Mark the drain plug 3 located on the bottom of the reducer unit
(Fig. D7/1).
- Place a small receptacle to catch the oil.
- Loosen the drain plug.
Dispose of the oil in an environmentally friendly manner
- Use a syringe to fill the reducer via the filling-breather cap 2 (Fig. D7/1). The
oil capacity is 1.3 litres and the level is correct when the breather is full of
oil.
- Re-insert the filling-breather cap 2 (Fig. D7/1).
To Next Page
Loading...
