Manitou 120 AETJ COMPACT - Page 57

3 - 11
3 - 11
D3 - DRAIN AND REPLACE THE REDUCINGS OF THE
REAR WHEELS
- Place the access platform on an horizontal ground in transportation position
and the warm oil of the reducings.
- Remove the rear wheels (Fig. D3/1).
- Place the cap of drainage 1 (Fig. D3/2) lower.
- Place a tray under the cap of drainage and unscrew it.
- Remove the cap 2 (Fig. D3/2) in order to facilitate the drainage.
- Let the oil to drain completely.
Dispose of the waste oil ecologically.
- Put the orifice 1 in the position like in the (Fig. D3/3).
- Fill up with oil (see chapter : LUBRICANTS) by the orifice 2 (Fig. D3/3).
- The level is good when the oil reaches the orifice 1 (Fig. D3/3).
- Replace and screw the caps 1 and 2 (Fig. D3/3).
- Rewind the wheel (see SPECIFICATIONS : wheel nut tightening
torque).
D3/1
D3/2
2
1
D3/3
2
1