2-37
SET-UP AT THE WORK AND LIFTING LOCATION
- The lifting platform is designed to operate on a flat, horizontal surface; it is important
to clear the space in which the lifting platform will be working.
- Bring the lifting platform to the work location.
- If necessary, load the equipment to be carried (stack it so that it does not hinder the
user and avoids the possibility of something falling off).
- Climb onto the lifting platform.
Safety helmets and harnesses must, compulsorily, be worn.
-
Press the “Dead Man’s” trigger and start to manoeuvre to position yourself in the
operating area.
When manoeuvring the lifting platform (lifting...), look all around and
below you. Pay particular attention to the electrical cables and any
item that may be in the lifting platform’s area of operation.
Become familiar with the instruments on the ground maintenance
and emergency station and in the basket described in the preceding
pages and, in particular, the warnings specifying the risks involved in
performing certain manoeuvres.
SAFETY SYSTEMS
- When the diagnostic displays show “OL” flashing, this means that the lifting platform
is overloaded and that no function is activated any longer. An alarm should sound.
• Solution : Push the red Emergency Stop knob to the OFF position. Relieve
the weight.
- When the lifting platform reaches the maximum authorised level of tilt, it must
stop rising and the tilt alarm should sound at 180 beeps per minute. The diagnostic
displays show “LL”. All “AGGRAVATING” raising movements are prohibited as a safety
precaution.
• Solution : set the lifting platform on a more horizontal surface, only making
movements that do not aggravate the situation further.
647369 (01/03/2017)
78/100 SEC 2 / 120 SE 2