2-36
USING THE LIFTING PLATFORM
MOVING IN TRANSPORT / OPERATING MODE
- The lifting platform has two distinct movement modes: transport mode (Fig. B) and operating mode (Fig. C) (progress direction (Fig. A).
- Transport mode: the lifting platform’s scissors are in the Low position. This mode enables you to move at high speed.
(See the CHARACTERISTICS chapter page 2-7).
- Operating mode: the scissors are raised. In this mode, translations are made at slow speed.
In operating mode, any movement over broken ground, unstable surfaces, slopes greater than the authorised angles of
inclination (see the CHAR
ACTERISTICS chapter, page 2-7), likely to cause the lifting platform to tip over or become
unbalanced, are FORBIDDEN.
In the case of a steep slope: place no load in the basket and use reverse gear.
TRANSPORT MODE
B
A
OPERATING MODE
C
REVERSE
TRANSLATION
FORWARD
TRANSLATION
647369 (01/03/2017)
78/100 SEC 2 / 120 SE 2
To Next Page
Loading...
