Manitou 80 VJR - Page 41

2 - 23
On completion of the operation, remember to close valve control again
(Ref.4, Fig. E) until it is in its original position - collerette flush
TO LOWER THE PENDULAR ARM :
- Remove the cap 6 (Fig. F).
- Screw the valve 7 (Fig. F).
- Screw the wheel 4 (Fig. E) until movement starts.
When the operation is complete, remember :
- to loosen the valve 7 (Fig. F) to its initial position.
- to refit the cap 6 (Fig. F).
- to unscrews the wheel 4 (Fig. E) to its initial position.
F
E
7
4
6