15
DORADO PRO 37MM SERVICE GUIDE
Insert the detent springs into opposite holes in the end
cap and place the detent balls on top of the springs. To
hold the detent balls in place on the spring use a small
dab of grease.
5
6
4
Install the high speed adjuster onto the end cap. Be sure that
O-ring # 100-025 below the adjuster is in place and greased.
Secure the adjuster with the c-clip (Retaining ring pliers can be
used to aid in the installation).
Use a 26mm socket to tighten it into the leg. Tighten to
6.8-9 Nm (60-80 in lb).
DAMPING LEG ASSEMBLY
To Next Page