Manitou DORADO PRO - Spring Leg Service Assembly

23
DORADO PRO 37MM SERVICE GUIDE
1
Inspect the inner leg, inside and out, clean it and be
sure it is free from debris and contaminants. Lube
the threads on bottom of the inner leg, lube the
outer diameter of the IRT air piston and the exposed
IRT shaft, and insert the assembly using a rotational
motion.
2
3
Use a cassette tool to tighten the IRT end cap to a
proper torque of 6.8 - 9.0 Nm [60-80 in lb].
Lube the threads on the inside of the inner leg, lube the
outer diameter of the air piston, and fill the piston cup
with 3cc of Slickoleum grease and 1cc Manitou 5w/40
Bath Oil.
SPRING LEG DISASSEMBLY