19
DORADO PRO 37MM SERVICE GUIDE
1
2
3
Release the air from the system. Remove the air caps
from the top and bottom of the fork leg. Release the air
pressure using a shock pump. Ensure all air is released
by gently depressing the air shaft with a 3mm hex
wrench.
ENSURE TO RELEASE AIR FROM BOTH MAIN AND IRT
CHAMBERS
The air spring leg top cap needs to be loosened.
Loosen the pinch bolt on the top crown, and crack the
top cap loose with a 16 notch Bottom Bracket Tool.
Loosen the pinch bolts on the lower crown, and
remove the leg from the fork. Be sure not to
misplace the frame bumper that will need to come
o the fork leg.
TIP: The ends of the Dorado sag guide can be used
to spread the clamps apart and aid in leg removal.
SPRING LEG DISASSEMBLY
To Next Page