6
DORADO PRO 37MM SERVICE GUIDE
1
Orient the fork with the knobs facing up. Using a 2mm
Allen wrench, remove the TPC+ adjuster knob.
NOTE: Be sure to hold the knob
still while removing the screw. The damper adjuster
may be damaged if the knob is over torqued.
2
3
Next you will remove the High Speed adjuster knob.
Remove the c-clip that holds the knob on using a snap
ring pliers or similar tool.
Remove O-ring and be sure you capture the 2 detent
balls and springs under the knob.
DAMPING LEG DISASSEMBLY
To Next Page
Loading...
